Sharp BK-RS08EB Manual Del Usuario página 17

Step 12: Remove the rear fender
a. Loosen the screws on the dropout with a 4 mm Allen key.
b. Use a 5 mm Allen key to push the bolt. Loosen the nut on the other side
with a 10 mm open-end wrench.
c. Then remove the rear fender.
Step 13: Remove the cable cover, rear brake caliper
and rear wheel
a. Loosen 2x Philips screws then remove cable cover.
b. Loosen the screws with a 5 mm Allen key. Then remove the rear brake
caliper.
c. Then you can remove the whole rear wheel easily from the bike.
Step 14: Remove the pedals
Loosen the pedals with a 15 mm open-end wrench. Then remove them.
EN