Sharp BK-RS08EB Manual Del Usuario página 11

Walk Assist
Pressing and holding the Down Button for 3 seconds activates Walk-Assist
Mode. The e-bike will go in a speed of up to 6 km/h automatically.
Settings Menu
Press and hold the Mode button for 2 seconds, and enter the Settings
interface.
How to set
Press the UP or Down to switch and press the Mode button to save.
When done, press the Mode button to go back to main settings menu.
If there is no action in one minute, it will exit the setting page
automatically.
Connect to SHARP Life APP
Press and hold the Mode button for 2 seconds, and enter the Settings
interface.
Select the About and scan the QR Code to download the SHARP Life APP
on your phone. Then link your lovely e-bike to your phone on the APP.
Error Code
If something is wrong with the electrical system, it will show an error code
on the display. Don't hesitate to get in touch with our service center to
troubleshoot the problems.
Here are definitions of the error codes.
Error code
21
23
24
30
How to use the lights
How to charge
a. Open the rubber cap and connect the light to a power supply with the
attached USB cable.
b. It finishes charging when the indicator light turns green.
c. Close the rubber cap after charging.
How to use the front light
Push the button to turn the light on.
Then Push to dim the brightness. Push again to turn the light off.
How to use the tail light
Push the button to turn the light on or off.
EN
Definition
Abnormal current
Motor out of phase
Motor Hall signal Fault
Communication Problem