Siderail Assembly Replacement - Stryker Performance-Pro Xt Manual De Uso Y Mantenimiento

SIDERAIL ASSEMBLY REPLACEMENT

Tools Required:
• T25 Torx Driver
Procedure:
1 . Raise the cot to the full upright position .
2 . Raise the siderail to the up and locked position .
3 . Using a T25 driver, remove the three spindle screws that secure the siderail assembly .
4 . Remove the siderail .
5 . Reverse the above procedures to install the new siderail assembly .
6 . Verify proper operation of the unit before returning it to service .
www.stryker.com
Service Information
6086-009-005 REV A
Return To Table of Contents
1-69
English