Using Restraint Straps - Stryker Performance-Pro Xt Manual De Uso Y Mantenimiento

English

USING RESTRAINT STRAPS

WARNING
Always use all restraint straps to secure the patient on the cot . An unrestrained patient may fall from the cot and be
injured .
Always secure the patient on the cot with all of the restraint straps .
To attach the restraint strap to the cot:
1 . Wrap the restraint strap around the cot frame as shown in Figure 37 .
2 . Push the restraint strap buckle through the loop as shown in Figure 38 .
3 . Pull the buckle through the loop to secure the restraint strap to the cot as shown in Figure 39 .
Figure 37: Wrap strap around cot
4 . Repeat steps 1-3 until all restraint straps are securely attached to the cot in the required attachment locations as
shown in Figure 40 .
Buckle the restraints across the patient's chest/shoulders, waist
and legs . Note the attachment locations in Figure 41 .
Keep the restraint straps buckled (as shown in Figure 40) when
the cot is not being used with a patient to avoid damage to the
buckles and straps .
Return To Table of Contents
1-36
Operation Guide
Figure 38: Push buckle through loop
6086-009-005 REV A
Figure 39: Pull strap to tighten
Figure 40: Restraint Strap Locations
www.stryker.com