Inner, Outer Tube Replacement - Stryker Performance-Pro Xt Manual De Uso Y Mantenimiento

English

INNER, OUTER TUBE REPLACEMENT

Tools Required:
• (2) Saw Horse
• 3/8" Combination Wrench
• 7/16" Combination Wrench
• T25 Torx Driver
• (2) 9/16" Combination Wrench
• Dead Blow Hammer
• 3/16" Allen Wrench
Procedure:
1 . Complete steps 1-7 from "Inner, Inner Tube Replacement" on
2 . Remove the inner tube .
3 . Using a T25 Torx driver, remove the screw that secures the base dead stop from the outer tube .
4 . Using a 7/16" combination wrench and a 3/16" Allen wrench, remove the two screws that secure the cap bearings
to the base litter interface bracket (one on each side) .
5 . Squeeze the head release handles and slowly remove the head section assembly .
6 . Using a 7/16" combination wrench and 3/16" Allen wrench, remove the bolt that secures the litter interface bracket .
7 . Using a 3/16" Allen wrench, remove the two screws that hold the litter interface bracket together .
8 . For the trend option, using a T25 driver, remove the two screws that secure the trend support bracket .
9 . For the gatch option, using a T25 driver, remove the four screws that secure the gatch support brackets .
10 . Pull outward on the outer rail until the litter interface bracket is off of the litter crosstube .
11 . Remove the outer tube from the litter crosstube and save the tube bushings to reuse on the new tube .
12 . Reverse the above procedures to install the new outer tube .
Note: Make sure that the X-frame guard screw hole on the new inner tube is facing the top of the cot when
reassembling .
13 . Verify proper operation of the unit before returning it to service .
Return To Table of Contents
1-68
Service Information
page
6086-009-005 REV A
1-65 .
www.stryker.com