Setup Procedures - Stryker Performance-Pro Xt Manual De Uso Y Mantenimiento

English
Ensure that all shipping and packaging materials have been removed from the product(s) prior to use.
Unpack the cartons and check all items for proper operation . It is important that the cot is working properly before it
is put into service . See "Figure 2: Cot Components" on
Before placing the cot into service, check these components:
• Check for loose fasteners . Replace if loose . Reference all assembly drawings .
• All welds are intact (not cracked or broken)
• No bent or broken tubing or sheet metal
• No debris in wheels
• All wheels are secure, and rolling and swivelling properly
• Both siderails move and latch properly
• Backrest operates properly
• Optional accessories are intact and operate properly
• Height positioning latch function operates properly
• Cot secure in each height position (see
• Undercarriage folds properly
• Retractable head section operates properly
• Safety bar operates properly
• Foot rest operates properly
• No rips or cracks in the mattress cover
• Body restraints are intact and operate properly
• Wheel lock(s) operate properly (optional equipment)
• Vehicle safety hook engages the safety bar so that the cot loads and unloads properly from the vehicle (see
1-15)
• Approved cot fastener (Stryker Model 6370/6377/6378/6379 or 6371 Cot Fastener − Not included) installed in the
vehicle (see
• Adjust cot load height (see
The patient compartment of the vehicle in which the cot will be used must have a:
• Smooth rear edge for cot loading.
• Level floor large enough for the folded cot.
• Stryker Model 6370/6377/6378/6379 or 6371 Cot Fastener System or Stryker Model 6390 Power-LOAD (not
included)
• 34" (86,4 cm) maximum loading height .
• Space to properly install the safety hook.
Note: Loose items or debris on the patient compartment floor can interfere with the operation of the safety hook and
cot fastener . Keep the patient compartment floor clear .
When necessary, modify the vehicle to fit the cot . Do not modify the cot .
WARNING
• Improper usage of the cot can cause injury to the patient or operator . Operate the cot only as described in this
manual .
• Do not modify the cot or any components of the cot . Modifying the product can cause unpredictable operation
resulting in injury to the patient or operator . Modifying the product also voids its warranty (see
Return To Table of Contents
1-12

Setup Procedures

page
page 1-13)
page 1-19)
page 1-7 to identify all of the cot components .
1-20)
6086-009-005 REV A
page
page 1-70) .
www.stryker.com