EN
This product requires a three-prong grounded outlet.
The installer must perform a ground continuity check on
the power outlet box before beginning the installation to
ensure that the outlet box is properly grounded. If not
properly grounded, or if the outlet box does not meet
electrical requirements noted (under ELECTRICAL RE-
QUIREMENTS), a qualified electrician should be employed
to correct any deficiencies.
CAUTION: For personal safety, remove house fuse or
open circuit breaker before beginning installation to avoid
severe or fatal shock injury.
CAUTION: For personal safety, the mounting surface
must be capable of supporting the cabinet load, in addi-
tion to the added weight of this 63-85 pound (28.5-38.5
kg) product, plus additional oven loads of up to 50 pounds
(22.7 kg) or a total weight of 113-135 pounds (51.3-61.2
kg).
CAUTION: For personal safety, this product cannot be
installed in cabinet arrangements such as an island or
a peninsula. It must be mounted to BOTH a top cabinet
AND a wall.
NOTE: For easier installation and personal safety, it is
recommended that two people install this product.
IMPORTANT - PLEASE READ CAREFULLY. FOR PERSONAL
SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED
TO AVOID SEVERE OR FATAL SHOCK.
IMPORTANT SAFETY INSTRUCTIONS
Ensure proper
ground exists
before use
The power cord of this appliance is equipped with a three-
prong (grounding) plug which mates with a standard
three-prong (grounding) wall receptacle to minimize the
possibility of electric shock hazard from this appliance.
You should have the wall receptacle and circuit checked
by a qualified electrician to make sure the receptacle is
properly grounded.
Where a standard two-prong wall receptacle is encoun-
tered, it is very important to have it replaced with a prop-
erly grounded three-prong wall receptacle, installed by a
qualified electrician.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT, DEFORM OR
REMOVE ANY OF THE PRONGS FROM THE POWER CORD.
DO NOT USE WITH AN EXTENSION CORD.
ELECTRICAL REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz, 15 amps and 1.6
kilowatts. This product must be connected to a seperate
and dedicated supply circuit of the proper voltage and
frequency. Wire size must conform to the requirements of
the National Electrical Code or the prevailing local code for
this kilowatt rating.
The power supply cord and plug should be brought to a
seperate and dedicated 15- to 20- ampere branch circuit
single grounded outlet. The outlet box should be located
in the cabinet above the microwave oven. The outler box
and supply circuit should be installed by a qualifed electri-
cian and conform to the National Electrical Code or the
prevailing local code.
3