Stihl RMI 422 Manual De Instrucciones página 85

Message:
4006 – Charging interrupted
Press OK to release
Possible cause:
– Error in programme sequence
– Power failure during charging
– Robotic mower rolled out of docking
station
Remedy:
– Confirm message with OK
– Check power supply to docking station
– the red LED flashes slowly when
robotic mower is docked (
– Check that docking station is in correct
position ( 9.1)
Message:
4009 – Hood sensor faulty
Press OK to release
Possible cause:
– Hood displaced
Remedy:
– Check position of the hood
– Check movement of the hood and clean
hood mounting if necessary
– Confirm message with OK
Message:
4016 – STOP button sensor value
deviation
Press OK to release
Possible cause:
– Error in the programme sequence
Remedy:
– Confirm message with OK
0478 131 9263 B - EN
Message:
4027 – STOP button pressed
Press OK to release
Possible cause:
– STOP button has been pressed
Remedy:
– Confirm message with OK
25. Troubleshooting
Support and help on use
13.1)
Support and help on use are available
from a STIHL specialist dealer.
Contact options and further information
can be found at https://support.stihl.com or
https://www.stihl.com.
If necessary, contact a specialist
dealer; STIHL recommends STIHL
specialist dealers.
Fault:
The robotic mower operates at the wrong
times
Possible cause:
– Date and time incorrectly set
– Active times incorrectly set
– Machine has been operated by
unauthorised persons
Remedy:
– Set time and date (
– Set active times (
– Set safety level to "Medium" or "High"
( 11.16)
Fault:
The robotic mower fails to operate during
an active time
Possible cause:
– Battery is charging
– Automatic mowing switched off
– Active time switched off
– Rain detected
– If mow plan type "Dynamic" is activated:
weekly mowing duration has been
reached, no further mowing operations
required that week
– Message is active
– Flap open or not present
– Docking station not connected to power
supply
– Outside allowed temperature range
– Power failure
Remedy:
– Allow battery to finish charging (
– Switch on automatic mowing (
– Release active time (
– Set rain sensor (
– No further action necessary, mowing
operations are automatically distributed
over the week in the mow plan type
"Dynamic" – if necessary, start the
mowing operation in the "Start" menu
(
– Rectify displayed fault and confirm
message with OK (
– Close flap (
– Check power supply to docking station
(
11.10)
– Allow the robotic mower to warm up or
11.7)
cool down – standard temperature
range for operation of the robotic
mower: +5°C to +40°C. Detailed
information is available from your
specialist dealer.
11.7)
11.11)
11.5)
24.)
15.2)
9.3)
15.7)
11.7)
83