Stihl RMI 422 Manual De Instrucciones página 81

– Uneven areas around or underneath
docking station floor plate
Remedy:
– Free robotic mower, remove obstacle or
change routing of perimeter wire if
necessary – then confirm message with
OK
– Check movement of hood and confirm
message with OK
– Level out uneven areas and confirm
message with OK ( 9.1)
Message:
1125 – Remove obstacle
Check wire routing
Possible cause:
– Perimeter wire routed inaccurately
Remedy:
– Check routing of the perimeter wire,
check clearances using the
iMOW® Ruler ( 12.5)
Message:
1130 – Stuck
Free iMOW®
then press OK
Possible cause:
– Robotic mower has become stuck
– Drive wheels are spinning
Remedy:
– Free robotic mower, level out mowing
area or change routing of perimeter
wire if necessary – then confirm
message with OK
– Clean drive wheels, if necessary
prevent operation during rain – then
confirm message with OK (
0478 131 9263 B - EN
Message:
1135 – Outside
Place the iMOW® on the mowing area
Possible cause:
– Robotic mower is located outside
mowing area
Remedy:
– Return robotic mower to mowing area
Message:
1140 – Too steep
Check wire routing
Possible cause:
– RMI 422:
Tilt sensor has detected a slope
inclination exceeding 35%
– RMI 422 P:
Tilt sensor has detected a slope
inclination exceeding 40%
Remedy:
– RMI 422:
Change routing of perimeter wire, block
off lawns with slope inclinations
exceeding 35%
– RMI 422 P:
Change routing of perimeter wire, block
off lawns with slope inclinations
exceeding 40%
Message:
1170 – No signal
Switch on docking station
Possible cause:
– Docking station is switched off
– No reception of wire signal during
11.10)
operation
– Robotic mower is located outside
mowing area
– Docking station or electronic
components were replaced
Remedy:
– Switch on docking station and give
mowing command
– Check power supply to docking station
– Check LED on docking station – the red
LED must be permanently illuminated
during operation ( 13.1)
– Return robotic mower to mowing area
– Link robotic mower and docking station
( 9.11)
Message:
1180 – Dock iMOW®
Automatic docking
not possible
Possible cause:
– The docking station was not found
– The start or end of a corridor was
installed incorrectly
Remedy:
– Check LED on the docking station,
switch on the docking station if
necessary ( 13.1)
– Check docking ( 15.6)
– Check funnel-shaped entrance and exit
areas of the corridor ( 12.11)
Message:
1190 – Docking error
Docking station occupied
Possible cause:
– Docking station occupied by a second
robotic mower
Remedy:
– Dock robotic mower once docking
station is unoccupied again
79