Chasing M2 PRO MAX Manual Del Usuario página 5

Release tether with CHASING E-Reel
EN
Press the button on the right Take out the tether from the
side of the straightener to straightener.
open the lid.
Retract tether with CHASING E-Reel
Press the button on the Install the tether into the
right side of the straightener straightener, as shown in
to open the lid. the picture. Close the lid
of the straightener.
3 Start (turn on) the ROV
Turn on the remote controller power button.A few
seconds later, the remote controller' s indicator lights
up, 5G or 2.4G light will be always on. The drone LED
lights will flash shortly, accompanied by two self-tests
sounds.
Check all the connectors and lights pre-dive, and
unlock the ROV when everything is ready underwater.
4
Connect remote controller to your phone/tablet
There are two methods to connect the remote controller with your mobile phone or
tablet. We recommend that you use Method 1: Connected by the Data Adapter Cable of
the Remote Controller. The connection methods are described as follows:
07
Method 1： USB Direct Cable Connection
Choose an appropriate remote controller
cable based on the type of mobile device. A
Lightning connector cable, micro USB cable,
and TYPE-C cable are included in the
packaging. Connect the end of the cable with
the mobile phone logo to the mobile device.
Close the lid， Start to wind
down the tether by hand.
Method 2： Wi-Fi Connection
On the Phone/Tablet, go to Wi-Fi
settings. Wait for 5-10 seconds and the
Chasing_xxxx network will appear as an
option. Click to connect and enter the
Wi-Fi password: 12345678
turn on the switch, rotate
the speed switch to slow/
fast speed and start winding.
Open the App and enter the camera, you will see the real-time scene transmission.
Settings
Back
Side menu bar
ROV state
model
3D Gesture
It is recommended to use this kind of way to connect mobile phone/tablet and remote
controller. * If the connection fails, please try to turn off your phone's Wi-Fi and mobile
network. If still fails, it may be a phone/ tablet compatibility problem. Please select method
2 Wi-Fi connection. * The remote controller type-c port and attached remote controller
cables do not support charging. *Check whether the O-ring on the tether connector
pre-dive. If it is missed or damaged, please replace it in time.
5
App interface Introduction
Compass
White balance state
Depth
Temperature
Relative angle
Light
You could check more guidance videos on the website page https://www.chasing.com/,or
you could contact the global support team with any questions ： support@chasing-innova-
tion.com
6:27 89%
Wi-Fi
Settings
Wi-Fi
Chasing_xxxxx
CHOOSE A NETWORK...
Gladius_5G_xxxxx
xxxxxxxxxx
xxxxxxxxxx
xxxxxxxxxx
SD card Signal
space strength Battery
percentage
One-key lock
White balance
SD Card ISO WB WE
AUTO AUTO
90G / 119G
ISO state
Switch
Photo/Video
Photo/Video
Camera
parameters
Settings
EN
08