Dometic COOLAIR RTX1000 Instrucciones De Uso página 20

Using the parking cooler
Control panel
1. Press the button until the
2. Press the or
10 minute intervals.
3. Press the button to save the value.
Remote control
1. Press the button to increase the required running time of the timer in 10 min
intervals.
RTX1000 24 V/RTX2000 24 V, SPX1200TC, SPX1200IC: The maximum
running time is 120 min.
RTX1000 12 V/RTX2000 12 V: The maximum running time is 600 min.
2. To save the value don't press any button for more than 5 s.
To reset the timer to 0 min, proceed as follows:
1. RTX1000 24 V/RTX2000 24 V, SPX1200TC, SPX1200IC: Press the
button until the timer shows 120 min.
1. RTX1000 12 V/RTX2000 12 V: Press the
600 min.
2. Press the button again.
3. To save the value don't press any button for more than 5 s.
7.10 Draining the condensate (SPX1200T, SPX1200C only)
The condensation water which accumulates due to the way the system works is auto-
matically extracted at intervals during operation. You can pump out the condensa-
tion water manually when necessary.
I
NOTE
Before winter, extract the condensation water from the system to avoid
damage caused by freezing water.
1. Press the button on the control unit briefly to switch the parking cooler into
standby.
2. Press and hold the
20
symbol appears.
button to set the required running time of the timer in
button and the
RTX1000/2000, SPX1200
button until the timer shows
button for more than 3 s.
EN