Dometic COOLAIR RTX1000 Instrucciones De Uso página 18

Using the parking cooler
7.6 Using the air conditioner
1. Set the required temperature (chapter "Setting the temperature" on page 18).
2. Set the required mode (chapter "Setting the mode" on page 18).
I
NOTE
If the required temperature is not reached in the energy-saving mode or
at a low fan speed, increase the fan speed or switch to BOOST mode or
to AUTO mode.
3. Set the timer (chapter "Setting the timer" on page 19), if you want the parking
cooler to switch off automatically after the required time.
7.7 Setting the temperature
I
NOTE
Depending on the set unit for the temperature, the temperature is
changed in steps of either 1 °C or 2 °F.
Control panel
1. Press the button until the
2. Press the or
3. Press the button to save the value.
Remote control
1. Press the + button to increase the temperature.
2. Press the – button to decrease the temperature.
3. To save the value don't press any button for more than 5 s.
7.8 Setting the mode
Control panel
1. Press the button until the
2. Press the or
3. To set the MANUAL mode see below.
4. Press the button to start the selected mode.
18
symbol is displayed.
button to set the desired temperature.
symbol is displayed.
button to set the AUTO, ECO or BOOST mode.
RTX1000/2000, SPX1200
EN