Skil RT1430B-00 Manual Del Propietário página 7

Never use router bits with a diameter exceeding the maximum diameter specified in the
"Specifications" section .
Do not use large router cutter bits for freehand routing . Use of large cutter bits when
freehand routing could cause loss of control or create hazardous conditions that could result
in serious personal injury. If using a router table, large bits should be used for edging only.
Be sure that the cutter bit is centered in a template guide (sold separately) prior to
template guide applications to avoid personal injury or damage to finished work.
Do not remove more than 1/8 inch (3 .2 mm) in a single pass . Excessive depth of cut can
result in loss of control that could result in personal injury.
After completing a cut, turn the motor OFF and let it come to complete stop before
removing router from workpiece . Let the motor come to a complete stop before putting
the router down . Cutter bits coast after the power is turned off.
If you are changing a bit immediately after use, be careful not to touch the collet/nut
or cutter bit with your hands or fingers . The heat buildup from cutting could cause severe
burns. Always use the wrench provided.
Avoid "climb-cutting" . "Climb-cutting" increases the chance of loss of control resulting in
possible serious injury. See "Feeding the Router" section in this manual.
Use only router bits with rated speed at least equal to the maximum no load speed
marked on the router . Router bits running faster than their rated speed can break and fly
apart.
Wear ear/hearing protection . Exposure to noise can cause hearing loss.
7