Maintenance - Skil Rt1430B-00 Manual Del Propietário

MAINTENANCE

WARNING
Service
WARNING
cause a serious hazard. We recommend that all service be performed by a SKIL Factory
Service Center or Authorized SKIL Service Station.
General Maintenance
WARNING
Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product
until all missing or damaged parts are replaced. Please contact customer service or an
authorized service center for assistance.
Cleaning
The router may be cleaned most effectively with compressed dry air.
WARNING
foreign matter. Do not attempt to clean by inserting pointed objected through openings.
WARNING
ammonia and household detergents that contain ammonia.
Collet Nut Care
Before each use, inspect the collet nut to make sure that it is clean and that it is gripping the
cutter bit properly.
With the router cutter bit removed, press the spindle lock button and turn the collet nut
counterclockwise until it is free from the spindle shaft. Blow the collet with compressed air and
clean the tapered inside of the collet nut with a tissue or a fine brush.
Always make sure that the cutter bit shank, collet nut, and spindle are clean and free of
woodchips, dust, gum and pitch residue, grease, and rust before installing a cutter bit or collet
nut.
Apply a slight amount of machine oil to the spindle shaft if it looks dry.
Replace a worn or damaged collet nut immediately.
The collet nut is self-releasing; it is not necessary to strike the collet nut to free
NOTICE
the router cutter bit. If the cutter bit seems to be stuck after use, loosen collet nut
a little more until it is released.
Cutter Bits
For faster, more accurate cutting results, keep cutter bits clean and sharp. Remove all
accumulated pitch and gum from cutter bits after each use.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep away from corrosive
agents.
24
To avoid serious personal injury, always remove the battery pack from
the tool when cleaning or performing any maintenance .
Preventive maintenance performed by unauthorized personal may
result in misplacing of internal wires and components which could
When servicing, use only identical replacement parts . Use of any
other parts could create a hazard or cause product damage .
Always wear safety goggles when cleaning tools with compressed air .
Ventilation openings and switch levers must be kept clean and free of
Certain cleaning agents and solvents damage plastic parts .
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents,
Some of