Skil RT1430B-00 Manual Del Propietário página 21

6. Pivot the tool clockwise around the nail to
make the circle cut (Fig. 12c).
7. When the cut is complete, turn the tool off
and allow the cutter bit to come to a complete
stop before removing it from the workpiece.
INTERNAL ROUTING (Fig. 13)
1. With the cutting depth set, tilt the tool and
place it on the workpiece, with only the
leading edge of the sub-base contacting the
workpiece.
2. Turn on the tool and allow it to attain its full
speed, being careful not to allow the cutter
bit to contact the workpiece.
3. To begin the cut, gradually feed the cutter bit
into the workpiece until the subbase is level
with the workpiece, then move the router to
make the cut.
4. When the cut is completed, turn off the tool
and allow the cutter bit to come to a complete
stop before removing it from the workpiece.
5. Remove battery pack and place the tool upside down on the worktable and inspect the
finished cut.
FEEDING THE ROUTER (Fig. 14)
When routing or doing related work, the best
finishes will result from setting up the cut
carefully, selecting the proper cutting depth,
knowing how the cutter bit reacts in the
workpiece, and selecting the appropriate rate
and direction of feed for the project.
Fig . 12c
Fig . 13
Fig . 14
1
Bit Rotation
4
Nail
3
Feed
Feed
2
21