Fixing The Engine To The Ceiling Support; Assembly Of The Blade; Insert Decorative Cap - Create Wind Tube Manual De Instrucciones

F I X I NG TH E E NGI NE TO TH E CE IL ING SUPP ORT
• Once the cables are connected and the receiver is placed inside
the motor, carefully unhook the motor body and fit it into the
ceiling support, securing it by making a small turn to align the
screw holes.
• Once the motor is secured to the bracket, install the two screws to
completely secure the motor to the ceiling bracket and secure the
four screws again.
• NOTE: Check that everything is securely fastened, that the screws
are tight and make sure that no cables have been pinched when
fitting the motor to the bracket.
AS SE M B LY O F TH E B L ADE
1
Place the washers on the blade screws. Align the blade holes with the motor screw holes and
secure them to the aligned holes. Repeat this process with the remaining blades.
I NSE RT DECOR ATIV E CAP
Align the decorative cap with the threads on the motor and tighten clockwise.
Now your fan will be properly installed so you can reconnect the power to enjoy your new
ceiling fan.
E NGL I SH
10
2