Chain Lubrication - Stocker 320 Manual De Instrucciones

8

Chain lubrication

Chain oil can lubricate and cool the chain. This chainsaw does not have an internal oil tank. To
lubricate the chain use the supplied oil transfer bottle by spreading a few drops of oil on the
chain. To distribute the oil over the entire chain, run the chainsaw „idle" so that the chain car-
ries the oil along its entire length. During this operation, the chain must not be in contact with
any object.
Chain sprocket maintenance
a. Users are not allowed to remove the chain sprocket themselves.
b. If the chain sprocket is damaged or defective; do not use the tool and contact your local
dealer or Stocker S.r.l.
190
Art. 320
Chainsaw ALL-ROUNDER E-100 UC
Cleaning and maintenance
Art. 320
Chainsaw ALL-ROUNDER E-100 UC
Cleaning and maintenance
Chain sharpening
Use a special round file with a diameter of 3/3.5 mm. Avoid using industrial grinders or
sharpeners.
Make sure the file only sharpens the chainsaw tooth blade forward and does not touch the
chainsaw tooth blade when it is pulled back. Sharpen the blade of the shortest tooth first, the
length of which will be used as the reference size of other blades in the chain:
a. The round file must adapt to the pitch of the chain.
b. The round file works on the cutting heads from the inside out.
c. File in one direction based on the tilt angle of the tooth head.
d. Please keep the angle of the tooth head.
e. Grind the small teeth of the cutting heads according to the depth of the groove of the bar. (See
figure above)
f. If you have any questions please contact your local dealer or Stocker S.r.l.
Sharpening
Cleaning and maintenance operations must be carried out with the
chainsaw off and battery disconnected
For further information about the product, please contact info@stockergarden.com
8
191