Stocker 320 Manual De Instrucciones página 93

7
When you turn off the tool, the chain will continue to run for a few sec-
onds. Wait for the chain to stop. Do not touch or block the moving chain.
Doing so poses a hazard!
1. If the chainsaw stops working after extended use and you see a slow flash, it is an indica-
tion of undervoltage protection, which means that the battery is flat. Recharge as soon as
possible.
2. If you encounter difficulties during branch cutting, during the pruning process, release the
trigger to stop the chain, then remove the bar from the branch, restart the chainsaw and
continue cutting.
The chainsaw must not be moved sideways during cutting, so as not to damage
the bar and chain.Never move the chainsaw from side to side when it is stuck.
184
Art. 320
Chainsaw ALL-ROUNDER E-100 UC
Usage
Art. 320
Chainsaw ALL-ROUNDER E-100 UC
Usage
Reading the LED display
In order to determine the battery charge level, the chainsaw is equipped with a power used
indicator light: „6", „7" and „8", which display the power of 100%, 60% and 20% in turn,
respectively.
The LED lights will be turned off from 100% to 20% in turn depending on the use. When all LED
lights are turned off, the battery should be charged immediately.
For further information about the product, please contact info@stockergarden.com
7
185