Changing The Wheel; Tyre Pressure; Mowing Height Adjustment Mechanism - Textron Ransomes Spider I Manual De Seguridad, Funcionamiento Y Mantenimiento

Operation manual - Spider ILD01

11.16 CHANGING THE WHEEL

Change the wheels on a level, firm surface
Turn the wheel so that the tightening nuts are
accessible from the outside
Stop the engine, remove the key from the
ignition
Secure the machine against movement.
Lift the mower and support it under the cutter
deck
Ensure the machine safe & supported before
working on it.
Loosen the wheel nuts, remove the wheel
After repairing it, attach the wheel back in the
reversed order.
Use suitable tools to unscrew the nuts.
To release the wheel from the hub,
unscrew only 3 nuts M12, the
remaining three bolts hold the two-
part rim of the wheel.
The two-part rim may be dismounted
(bolts unscrewed) only it the tyres are
deflated.

11.17 TYRE PRESSURE

Keep the specified tyre pressure. Other values may
unfavourably influence the riding characteristics
especially on slopes. You may even loose control of
the machine.
(max. tire pressure - 250 kPa / 2,5 bar / 36 PSI)

11.18 MOWING HEIGHT ADJUSTMENT MECHANISM

Keep the moving parts of the slide way clean,
undamaged and without an excessive clearance
43 / 54 rev. 07-01-01-2010