Replacement Of The Pilot Light Injector; Equipment Decommissioning, Demolition And Disposal - Angelo Po 1N1Pi1G Manual De Uso

To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Open the hatch (A).
2)
Unscrew the union (B).
3)
Remove the nozzle (C) and replace it with
4)
the one suitable for the type of gas in use
(see table at back of manual).
Screw the union (B) back in place and close
5)
the hatch (A).

EQUIPMENT DECOMMISSIONING, DEMOLITION AND DISPOSAL

When decommissioning the appliance, a series
of procedures must be carried out to ensure
that the appliance and its components are not a
hindrance and are not easily accessible.
To ensure that the appliance cannot constitute
hazards for people or the environment, all ener-
gy sources (electricity, etc.) must be disconnect-
ed and rendered unusable, and any liquids pre-
sent must be drained (lubricants, fl uids, etc.).
Place the appliance in a suitable area which is
not easily accessible, with barriers to prevent an-
yone from accessing it.
3320160_inst_GB_rev.1

REPLACEMENT OF THE PILOT LIGHT INJECTOR

A
When scrapping, sort all components by chemi-
cal characteristics and dispose of them sepa-
rately in accordance with the relevant legal re-
quirements.
Important Importante
Do not dump non-biodegradable products,
lubricating oils, and non-metallic compo-
nents (rubber, PVC, resins, etc.) in the envi-
ronment. Dispose of them in compliance with
the relevant laws.
- 17 -
B
C
GB
ENGLISH