Hisense RVCLS144AB HSN Manual De Instrucciones página 9

Robot charging
Before first use, put robot on the
station closely, and make sure robot
is in charging status for first use,
then start robot.
For future use, robot can
automatically goes to the charging
base when cleaning is finished.
Instructions prior to use
1. Prior to startup, clear away sundries
on the floor, and remove easily falling,
fragile, valuable, and possibly
hazardous items.
2. Use relevant objects to block
the robot, or establish a
virtual wall in the App.
3. If there is an area that does not need cleaning or may trap
the robot, you can add a prohibited area or virtual wall at the
appropriate location in the map of the App, to prevent the
robot from entering specific areas.
Cautions
1. If the robot cannot be charged, check whether the charging
chips on the robot's bottom are blocked by fair bundles of left
and right side brushes.
If yes, manually rotate relevant side brush to eliminate such
blockage.
EN-15
OPERATING GUIDELINES
Power-on methods
1. When putting the robot in the charging station to charge, it will
turn on automatically (recommended practices).
2. Long press " " for 3 seconds, the power indicator flashes, the
robot sounds a chord voice, and the power indicator is
continuously on, indicating the robot is powered on successfully.
Start the cleaning
1. During the standby mode, briefly press "
and the robot starts to clean the whole room.
2. If you want to mop the floor, it is required to confirm that the
vibration mopping assembly is installed properly.
Pause the cleaning
During the cleaning, briefly press "
pauses the cleaning and enters its standby status.
Return to charge
1. When the robot returns to charge after completion of the
cleaning, the return-to-charge indicator is continuously red.
When the robot returns to charge due to low battery level, the
return-to-charge indicator flashes.
2. ① During the standby mode, briefly press "
the robot starts to return to charge.
② During the cleaning, briefly press "
robot pauses the cleaning; then briefly press "
and the robot starts to return to charge.
3. In case of special conditions (such as depleted battery, stuck
robot etc.), the main unit may not return to charge automatically.
Please manually place the main unit back to its charge station to
charge.
Troubleshooting
When the robot fails, the power indicator flashes quickly. Briefly
press " " for 1 second to eliminate the fault.
EN-16
" for 1 second,
" for 1 second, and the robot
" for 1 second, and
" for 1 second, and the
" for 1 second,