Hisense RVCLS144AB HSN Manual De Instrucciones página 10

Connect Robot to Station
1. Fast Connect: When robot is under powered-o status, long
press " " for 3 seconds.
The connection will automatically complete after robot turned
on. A sound of "Di-du" means connected successfully.
2. Connect Manually: When robot is under powered-on status,
long press " " and " " for 3 seconds at the same time. If
connected successfully, a "Di-du" sound will be heard and
station indicator light will flicker 3 times.
Power o
1. Long press " " for 3 seconds, and the power indicator starts to
flash.
2. The robot sounds a chord voice, and the power indicator is o ,
indicating the robot is powered o successfully.
Cautions
1. When it is not possible to
start the cleaning due to
low battery level, please
charge the robot before
starting the cleaning.
3. During the charging, the
power indicator flashes
slowly, and becomes
continuously on after
completion of the
charging.
5. The robot cannot be powered o when being located in the
charging station, and if you need to power it o , remove it from
the station.
EN-17
2. The robot will return to
charge automatically during
the cleaning in case of low
battery level, and then return
to its interruption point to
proceed after being fully
charged.
4. The robot will enter its sleep
mode after being standby for
more than 10 minutes, and in
this mode, pressing any key
on the robot will awaken it.
or
Dust Collection Methods
1.
Setting of dust collection time and frequency:
Dust collection settings can be changed on the ConnectLife
Robot app.
The dust collection length can be set from 6 to 14 seconds.
The dust collection frequency can be set 1 time, 3 times or 5
times after cleaning.
2. Auto Dust Collection:
The dust collection station will start to work automatically
when the robot returns to the dust collection station as it
reaches the scheduled cleaning times.
3. Manual Dust Collection:
When the cleaning is finished, the robot can be returned to
the dust collector station manually. Dust collection will
automatically start when the robot reaches the scheduled
cleaning times.
Manual Dust Collection through APP:
4.
When the robot returns to the charging station,
press "Manual dust collection" to start dust collection.
NOTE: To extend the life of motor, dust collector station will
progressively increase the power. It is normal to hear the sound
louder during the collection.
EN-18