Hisense RVCLS144AB HSN Manual De Instrucciones página 8

Use guide for vibration mop assembly
1. Press the button on tank
and pull to remove.
Water Tank
3. Adhere the special rag for
vibration mopping to the
bottom of the vibration
mopping assembly by
aligning it along the middle
seam, and you can
clean/replace it by simply
peeling it o .
Special rag for vibration mopping
Cautions
1. Fill the tank with municipal
water instead of purified
water.
EN-13
2. Remove the rubber plug,
and fill the tank with water
to the MAX line.
Water inlet/outlet
4. Push the vibration
mopping assembly in the
main unit until a "click"
sound is heard.
2. Do not add washing powder,
laundry detergent, cleaning
agents, disinfectants, hand
sanitizers, unknown oily
liquids, and alkaline
substances.
3. Do not use the mopping
function on floor carpets.
5. Keep the terminal dry and
clean before pushing in the
vibration mopping
assembly.
Terminal
Installation of side brushes
1. By keeping the side brush
color consistent with the
side brush slots on the
base of the main unit, push
the side brush into the slot
directly until a "click"
sound is heard.
EN-14
4. Do not fill the tank with hot
water to prevent its
distortion at high
temperature.
6. The mopping water volume
can be adjusted in the App.
Water speed
2. To remove the side brush,
turn the robot's bottom
upwards, and grasp the
side brush by its
rubber-coating leg (take
care not to pull on hair
bundles of the side brush
with brute force) with your
two hands to pull it o .