User Qualification; Assembly; Administration/Network Operation; Measuring Mode - Seca 655 Instrucciones De Uso

2.5

User qualification

Assembly

Administration/network operation

Measuring mode

2.6

Functional description

Measuring weight/entering height

Measuring weight and height

Mobile measuring

Network functions

114 • seca 655/654; seca 455; seca 257/256/254; seca 453
Devices shipped partly assembled may only be assembled by sufficiently quali-
fied persons (such as specialist dealers, hospital technicians or seca Service
technicians).
The device may only be set up and incorporated in a network by experienced
administrators or hospital technicians.
The device may only be operated by persons with formal training in the health-
care sector or in medicine.
Weight calculation is performed by four load cells. The measured results are
shown on the multifunctional display. Height is entered manually.
Body Mass Index (BMI) or Body Surface Area (BSA) are calculated automatically
as soon as a height is entered.
Weight and height can be recorded simultaneously if a compatible measuring
rod is fitted to the scale. Body Mass Index (BMI) or Body Surface Area (BSA) are
calculated automatically.
The measuring rod records height by means of ultrasound. The
seca 257/256
patient is guided through the measurement using configurable voice output.
The digital telescopic measuring rod records the height of individuals
seca 254
≥ 1.22 m by scanning a digital scale. For individuals < 1.22 m, height must be
read off the measuring rod and entered manually on the multifunctional display
of the scale.
Using the battery pack available as an option, you can use the device
seca 453
on a mobile basis (not recommended for device combinations involving the ultra-
sonic measuring rod).
With rechargeable battery operation, measured results can only be transmitted
to patient files manually. Network functions (e.g. calling up patient data, saving
measured results) are not available. Network settings are retained during
rechargeable battery operation and are available as soon as the device is being
operated on a stationary basis (supplied with power by the power supply unit)
again.
The device can be integrated into a PC network via a LAN interface or via WiFi.
The software is required to set up this integration.
seca connect 103