Boss JS8 eBand Manual De Instrucciones página 32

Convenient Functions
CHORUS parameter list
Parameter
OFF/ON
Turns the CHORUS OFF/ON.
Use this to choose the type of chorus.
MONO
ST 1
TYPE
ST 2
MN MLD
ST1 MLD
ST2 MLD
This sets the speed of the effect.
RATE
When set to BPM, the value of the RATE parameter is set according to the value of the "EFFECT TEMPO" (p. 30)
specified for each patch. This makes it easier to achieve effect sound settings that match the tempo of the
song.
DEPTH
This sets the richness of the effect.
EFFECT LEVEL
This sets the volume level of the effect.
REVERB parameter list
Parameter
OFF/ON Turns the REVERB OFF/ON.
Use this to choose the type of reverb.
AMBI.
ROOM
TYPE
HALL 1
HALL 2
PLATE
REVERB TIME
Adjusts the length (time) of reverberation.
The high cut filter adjusts the amount of high frequencies in the reverb sound. When "FLAT" is selected, the high
HIGH CUT
cut filter will have no effect.
EFFECT LEVEL
This sets the volume level of the effect.
EZ CHARACTER parameter list
Parameter
EFFECT TEMPO
EZ CHAR
30
This chorus effect outputs the same sound from the left and right channels.
This is a stereo chorus effect that adds different chorus sounds to L channel and R channel.
This stereo chorus uses spatial synthesis, with the direct sound output in the left channel
and the effect sound output in the right channel.
This features a more suppressed high end than MONO.
This features a more suppressed high end than ST 1.
This features a more suppressed high end than ST 2.
Simulates an ambience mic (off-mic, placed at a distance from the sound source) used in
recording and other applications. Rather than emphasizing the reverberation, this reverb is
used to produce a sense of openness and depth.
Simulates the reverberation in a small room. Provides warm reverberations.
Simulates the reverberation in a concert hall. Provides clear and spacious reverberations.
Simulates the reverberation in a concert hall. Provides mild reverberations.
Simulates plate reverberation (a studio effect unit that uses the vibration of a large metal
plate to produce reverberation). Provides a metallic sound with a distinct upper range.
This sets the tempo when RATE parameters such as DELAY TIME, PHASER, and FLANGER are synchro-
nized to the song tempo.
Set DELAY TIME and RATE to (Whole Note)-(16th Note).
You can also input the tempo by tapping [SPEED] in time with the beat (TAP function).
This adjusts the character of the guitar tone, ranging from solo tone (-20) to a tone used for backing
(+20).