Phrase Trainer - Boss Js8 Eband Manual De Instrucciones

Phrase Trainer

Repeating Playback of a Fixed
Segment (AB REPEAT)
1. Press [w](PLAY).
2. Press [A B] at the start point, and
again at the end point of the segment
to be repeated.
Use this feature for guitar solo practice and in other situa-
tions where you want to practice along with a single section
as it plays back repeatedly.
To turn AB Repeat off, press [A
Precise Adjustment of the AB REPEAT
Segment
You can precisely adjust the start and end points of the
segment to be repeated.
1. In the Top screen, press [MvENU].
2. Select METRONOME with the dial and press [ENTER].
3. In the AB REPEAT EDIT screen, adjust the start point (A)
and the end point (B).
• You can press [ENTER] in the AB REPEAT EDIT screen to
alternately switch the AB REPEAT function on and off
without clearing the markers.
• With MP3 data, you may be unable to play back from a
specific time (the performance starts near the speci-
fied time). In such cases, if you want playback to start
at an exact point, use the CONVERT function (p. 38) to
convert the file to a JS-8 song.
• The interval between A and B cannot be less than one
second.
Phrase Trainer settings are saved as part of each song on
the SD card. However, these settings are not saved for
songs in USB memory or protected songs.
This icon
is shown if AB
Repeat is on.
B] once again.
The
PH.TRAINER
icon will be lit
if Speed, Pitch,
or Center
Cancel are on.
Play Your Guitar with Songs as Your Backing
Practicing with the Song Tem-
po Changed and Center Sound
Removed
Press [SPEED].
This lets you slow down the song tempo to practice faster
passages and remove the center sound from songs so you
can use them for backing as you perform.
Press the right cursor button to
switch to the screen for the pitch
Screen 1
(Screen 2).
This sets the song
speed.
Normally, the speed
is set to 100%.
Set this to ON to remove the sounds
heard in the center (Center Cancel).
Press the right cursor button to
switch to the screen for finely adjusting
the Center Cancel quality (Screen 3).
Screen 2
Raises or lowers the
pitch in semitone steps.
Screen 3
Specify the
location in the
sound field of the
sound you want
to eliminate. C0
Specify the frequency range
eliminates the
of the sound you want to
sound that's in
eliminate.
the center, L**
• HIGH: High frequency range
and R** eliminate
• MID: Middle frequency range
sounds at the left
• LOW: Low frequency range
or right, respec-
tively.
• The center cancel effect is also obtained on the sound be-
ing input via AUX IN and USB.
• Depending on the recorded audio, it may not be possible
to completely eliminate the sound.
Adjusts the pitch in
fine steps of 1 cent.
Increasing
this value will
remove the
sound more
completely.
15