Return / Clear; Selection Of The Reference Point - Parkside Plem 50 C3 Instrucciones De Utilización Y De Seguridad

Length
0.000 m
0.000 ft
0'0 1/1₆ in
0'0 1/1₆

Return / Clear

Press "Return / Clear" button
measured value and go back to previous value (or) go back
to previous mode.
Press "Return / Clear" button
to Home-screen mode (see chapter "Start-up", section "Home-
screen mode").
Note: Pressing "Return / Clear" button
measurement mode will stop the measurement.

Selection of the reference point

The reference point (back)
piece) or the reference point (front)
28
used as the contact surface for any measurement. The reference point
is to be set before measurement. Otherwise, the measured result
differs from actual value. The default reference point setting is from
the reference point (back)
can be changed by pressing the reference button
Area
0.000 m
2
0.000 ft
2
0.00 ft
2
0.00 ft
2
(base) or the reference point (end
29
of the product. The reference point
29
Volumes
0.000 m
3
0.00 ft
3
0.00 ft
3
0.00 ft
3
at any mode to clear latest
8
multiple times to go back
8
under continuous
8
of the product can be
30
repeatedly
12
GB/IE 47