Inserting / Replacing The Batteries; Start-Up; Power On / Off - Parkside Plem 50 C3 Instrucciones De Utilización Y De Seguridad

Remove all packaging material from the product.
Remove protective foil from the display

Inserting / replacing the batteries

When the low battery icon
still make measurements. As soon as the battery icon turns empty
however, you must replace the batteries. Measurements are no
longer possible.
Open the battery compartment cover
down the battery compartment cover latch
Remove the used batteries from the battery compartment
if necessary.
Insert the (new) batteries. Ensure the correct polarity as shown
on the diagram inside the battery compartment
Replace the battery compartment cover

Start-up



Power ON / OFF

Press power button
beam will be activated from the laser beam output opening
Laser on icon
Press and hold the power button
off to power off the product. The laser beam flashes again shortly
before it is finally switched off.
appears in the display
to power on the product. The laser
11
will also be shown on the display
31
.
2
2
by gently pushing
5b
.
32
.
5a
as shown (fig. A).
5b
until the LC display turns
11
, you can
,
,
5a
.
4
.
2
GB/IE 45