Removing The Transformer With Twinfix - JANE CONCORD TRANSFORMER iPLUS Manual Del Usuario

ATTENTION!
• TWINFIX is an additional attachment system to stabilize the TRANSFORMER
and does not replace the security using the safety belt.
• Children and the seat without a child must always be secured using the
vehicles own 3-point safety belt.

_ REMOVING THE TRANSFORMER WITH TWINFIX

To remove the TRANSFORMER, pull the TWINFIX button (09) forwards and move the
seat fully forwards. Next, slide the locking buttons on the outer sides of the TWINFIX
adapters (10) forwards until the safety indicators are red.
Now pull the seat forwards and away from the ISOFIX points.
Lay the seat with the back on a flat surface.
Pull the TWINFIX button (09) and then press down on the seat section of the child seat
until the TWINFIX adapters (10) are fully retracted!
To avoid damaging the outside of the seat, check that the surface you place it on is
clean, smooth and as soft as possible! 3.b
3.a
EN
29