Hisense RF793N4SASE Manual De Operación página 56

6.Changing the water filter
To drink the freshest and cleanest water from
your refrigerator, change the filter on time. To
change the water filter, follow these steps:
1.Shut off the water supply. Pull out the cover
(B) about 1.5 cm and open.
2. Turn the water filter (C) about 1/4 turn,
counter-clockwise. Then pull the water filter
from the filter holder.
Note:
Sometimes, it is hard to disassemble the water
filter because impurities in the water cause it
to stick. If you are having difficulties, grip the
water filter firmly and pull it out.
When you pull the water filter, a little water can
leak from the opening.
This is normal. To minimize the water leaks,
keep the filter cartridge horizontal when
pulling it.
To insert the new water filter, follow the
directions below.
25
3. Insert the new filter into the filter holder.
4. Push the filter, and then turn it clockwise until it
locks
If you have trouble inserting the water filter
because of high water pressure, shut off the
water supply valve.
5. If you turned off the water supply, turn it back on.
Note:
After turning on the water supply, you should
check the leaks. If leaks occur, repeat the steps
1- 5.
If leaks persist, discontinue use and call
customer service。
Removing any residual matter inside the water
supply line after installing the water filter
1. After the water filter is replaced, dispense 2.5
gallons of water (flush for approximately 5
minutes) to remove trapped air and
contaminants from the system.
2. Additional flushing may be required in some
households.
3. Open the refrigerator door and make sure
there are no water leaks coming from the
water filter.
Note:
Sometimes, it is hard to disassemble the water
filter because impurities in the
water cause it to stick. If you are having
difficulties, grip the water filter firmly and
pull it out.