Important - Dea Net24N Instrucciones De Uso Y Advertencias

6 STANDARD PROGRAMMING
1
Power Supply
Give power supply, the display shows the following symbols "
*
If the control panel has already been programmed and the power fails or is switched off - once power is returned and a START
command is given, the position reset procedure is performed (see "rESP" in the table "WORKING STATUS MESSAGES" on page 35.
2
Visualisation of inputs and operations-counter status
1. Press the key for 15 seconds;
2. The display will show respectively:
Inputs status (check it's correct);
Total operations counter (* see P064):
i.g.: = 3x100* = 3000 operations performed
Maintenance operations-counter (* see P065):
i.g.: = 5*x500 = 2500 operations remaining
before the maintenance intervention request (
manoeuvres-counter disabled)
3. Hold down the key to display a cyclic 3 options, or
release the button to exit the parameter.
3
Selection type of operators
1. Scroll down the parameters with
sualise P028;
2. Access the parameter by pressing the
3. Acting on and keys, set:
Type 00 Type 01
• 005 5/24 • 000 Geko - Angolo
• 006 8/24 • 001 Look - Mac
• 007 Gulliver - Rev • 002 Ghost
• 003 Livi 500 - 502
- 550PL
Warning: If you are using non DEA System operators, set the pa-
rameter on the closer value for family type and performances (refer
to table on page 20).
4. Confirm your choice by pressing the
again to P028).
=

! IMPORTANT !

and keys until you vi-
key;
Type 02 Type 03
• 003 Livi 902/24 - • 003 Pass
905/24 • 004 Stop
key (display returns
", " ", " " (or the Type selected) and then "----".
25