Porter Cable FN250 Manual De Instrucciones página 3

7. CONNECT TOOL TO AIR
SUPPLY HOSE with a coupling that
removes all pressure from the tool
when the coupling is disconnected.
8. DISCONNECT TOOL FROM
AIR SUPPLY HOSE before doing
tool maintenance, clearing a jammed
fastener, leaving work area, moving
tool to another location, or handing
the tool to another person.
9. NEVER USE A TOOL that is
leaking air, has missing or damaged
parts, or requires repair. Make sure
all screws and caps are securely
tightened.
10. NEVER USE TOOL IF SAFETY,
trigger or springs are inoperable,
missing or damaged. Do not alter or
remove safety, trigger, or springs.
Make daily inspections for free
movement of trigger and safety
mechanism.
11. DO NOT USE TOOL WITHOUT
SAFETY WARNING LABEL. If label
is missing, damaged or unreadable,
contact your Porter-Cable Service
Center for a replacement.
12. ONLY USE PARTS, FASTEN-
ERS, AND ACCESSORIES recom-
mended by Porter-Cable.
13. CONNECT TOOL TO AIR
SUPPLY BEFORE loading fasten-
ers, to prevent a fastener from being
fired during connection. The tool
driving mechanism may cycle when
tool is connected to the air supply.