Important Safety Instructions - Porter Cable Fn250 Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS :
WARNING: When using pneumatic tools, basic safety precautions should
always be followed to reduce the risk of personal injury, including the
following:
READ AND FOLLOW ALL INSTRUCTIONS.
There are certain applications for which this tool was designed. Porter-Cable
strongly recommends that this tool NOT be modified and/or used for any
application other than for which it was designed. If you have any questions
relative to its application DO NOT use the tool until you have written Porter-
Cable and we have advised you.
1. USE SAFETY GLASSES. To
prevent eye injuries, the tool operator
and all persons in the work area must
wear safety glasses with permanently
attached, rigid, plastic side shields.
These safety glasses must conform to
ANSI Z87.1 requirements (approved
glasses have "287" printed or
stamped on them).
2. WEAR EAR PROTECTION to
safeguard against possible hearing loss.
3. USE CLEAN, DRY, REGULATED
compressed air at 70 to 120 PSI, (4.8 to
8.3 BAR).
4. DO NOT CONNECT TOOL TO
pressure which potentially exceeds
200 PSI (13.7 BAR).
5. ONLY USE AIR HOSE THAT IS
RATED for a maximum working
pressure of 150 PSI or 150% of the
maximum system pressure, which
ever is greater.
6. NEVER USE OXYGEN,
CARBON DIOXIDE, combustible
gases or any other bottled gas as a
power source for this tool: explosion
and serious personal injury could
result.
Technical Service Manager
Porter-Cable Corporation
4825 Highway 45 North
P. O. Box 2468
Jackson, TN 38302-2468