Aiwa HS-RX748 Operating Instructions página 36

36
PRESETTING Eri
When auto presetting starts while receiving a station
That station is set to preset number 1, and scanning proceeds
from this point to higher frequencies. When the scanning
process reaches the high end of the frequency range, it returns to
the low end and finishes when it comes to the point where the
auto preset was started.
If there is a station you wish to skip during presetting
When a station is tuned in, scanning stops and the tuned station
can be heard for 3 seconds. Press the MODE/SET button within
these 3 seconds to deselect this station.
Note
¢When broadcast signals are very weak, stations cannot be
preset automatically. Preset manually.
Auto presetting ends after 6 stations are preset.
¢The preset stations remain selected even after the batteries are
removed. However, they may not be retained correctly if the
batteries become low on power or are removed while the unit is
on.