Yvolution YES Manual Del Usuario página 10

7. Dashboard display information
Power :
Long press (3 seconds) button to turn ON/OFF
The display will light up to indicate the scooter is ON. The screen will show
"00". If a E appears on the screen, refer to error codes section below.
Lights :
When the scooter is on, press the button once to turn the lights
ON. When the lights are on, press the button once to turn the lights OFF
Speed settings :
Double press the button to cycle through the 3 speed settings:
Mode 1 – 6km/h - 4miles/h (displayed as 1 on the screen)
Mode 2 – 18km/h - 11miles/h (displayed as 2 on the screen)
Mode 3 – 25km/h - 15.5miles/h (displayed as 3 on the screen)
The scooter will remember the mode chosen when it is turned off.
Display unit change :
Triple press the button to change Kilometers per hour to Miles per hour.
8. Error codes
If you press on the accelerator of the e-scooter and it does not move, please look at the
screen to see if an error code is displayed along with a small red spanner. This number
displayed corresponds to a specific fault which needs to be fixed before the scooter
will operate normally. The fault code are as follows:
Showing 00: under-voltage, indicating battery needs to be charged, after
charged, the fault can be removed; When the battery voltage is 30V, the
under-voltage fault will be showed.
8