Health And Safety Information; Declaration Of Conformity; Exemption From Liability - Car Repair System Dual Channel Manual De Instrucciones

RoHS Compliant
This product and the associated component parts are "RoHS Compliant" and do not contain any of the sub
stances in excess of the maximum concentration values in EU Directive 2002/95/EC, as amended by Com-
mission Decision 2005/618/EC and other amendments issued as of the date code marked on the product.
Waste Electrical & Electronic Equipment (WEEE) Compliant
• Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.
• Contact your local government for information regarding the collection systems available.
• If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your health and well-being.
• When replacing old appliances with new ones, the retailer is legally obligated to take back your old
appliance for disposal at least for free of charge
Federal Communications Commission (FCC) Compliance Statement
IMPORTANT NOTE : This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide a reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This equip-
ment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
We declare under our sole responsibility that the product described under "Technical Data" conforms to
the following standards or normative documents:
EN 60335-1, EN 60335-2-29, EN 55014-1
EN 55014-2, EN 61000-3-2, EN 61000-3-3
EN 62233: 2008, 2014/35/EU, 2014/30/EU
CAR REPAIR SYSTEM, S.A.
Polígono Industrial 2 de Octubre.
Calle José Muñoz 6, 18320 Santa Fe.
Granada. España
The manufacturer and his representative are not liable for any damage and lost profit due to interruption in
business caused by the product or by an unusable product. The manufacturer and his representative are not
liable for any damage which was caused by improper use of the power tool or by use of the power tool with
products from other manufacturers.

HEALTH AND SAFETY INFORMATION

DECLARATION OF CONFORMITY

EXEMPTION FROM LIABILITY

Nelson Simões -Technical and commercial Director.
Car Repair System, S.A.
EN
9