Status Indication - Car Repair System Dual Channel Manual De Instrucciones

EN

STATUS INDICATION

1- Red Lights
Flashing: Damaged or faulty battery pack
Continuous: Battery is too hot/cold, charging will begin when battery reaches correct charging temperature
2. Green Lights
Fast flashing: Charging
Slow flashing: Approaching full charge
Very slow flashing: Waiting, charging will begin when the first pack is fully charged
Continuous: Charging is completed (with pack)
Stand by (without pack)
3.Self-check
4 lights flash in turns
4.Charger Faulty Indication
Faulty Charger: 4 lights flash at the same time
Faulty Charger Cooling fan: Red light flashes like ^^_^^_
- If the charger faulty sign appears, or if the stand-by sign does not come on, remove pack(s) and unplug
charger for at least 2 minutes. After 2 minutes, plug charger back in and insert pack. If the problem persists,
contact the service center for check.
- If the battery pack faulty sign appears, try to reinsert the pack, if the same faulty sign happens on all other
good packs, the charger may be in faulty, contact the service center for check.
WHEN TO CHARGE THE BATTERY PACK
- New battery pack need to be charged before use.
- Remove the battery pack from the tool for charging when convenient for you and your job. CAR REPAIR SYS-
TEM batteries do not develop a "memory" when charged after only a partial discharge. It is not necessary to
run down the battery pack before placing it on the charger.
- The battery packs not in often use need to be charged for each 3 months.
- The long-time uncharged battery pack may enter into a "sleep" status due to the gradually dropping down
of voltage, charger may not be able to reactivate it. Such battery pack needs to be sent to the service center
to reactivate with special equipment. The reactivation is not guaranteed to be successful subject to battery
condition.
7