Intended Use - Car Repair System Dual Channel Manual De Instrucciones

16.BATTERY CHEMICALS CAUSE SERIOUS BURNS. Never allow contact with skin, eyes, or mouth. If a dama-
ged battery pack leaks battery chemicals, use rubber or neoprene gloves to dispose of it. If skin is exposed
to battery fluids, wash with soap and water and rinse with vinegar. If eyes are exposed to battery chemicals,
immediately flush with water for 20 minutes and seek medical attention. Remove and dispose of contamina-
ted clothing.
18.DO NOT ALLOW FLUIDS TO FLOW INTO BATTERY PACK. Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach containing products, etc., can cause a short circuit.
19.STORE YOUR BATTERY PACK AND CHARGER IN A COOL, DRY PLACE. Do not store battery pack where tem-
peratures may exceed 104°F (40°C) such as in direct sunlight, a vehicle or metal building during the summer.
20.THIS CHARGER AND BATTERY PACK ARE NOT INTENDED FOR USE BY CHILDREN AND PERSONS WITH PHY-
SICAL, SENSORY OR MENTAL LIMITATIONS OR A LACK OF EXPERIENCE OR KNOWLEDGE.
input: 100-240 v 50/60 Hz
Rated Input Power : 160 W
Output 1: 18 VCD, 6,5 Amps
Output 2: 18 VCD, 6,5 Amps
Recommended Ambient - +4°C to +40°C
The battery charger is designed for charging CAR REPAIR SYSTEM batteries of types:
Estimated Charging Time:
- Li-on Battery 2,5 Ah: 30 min.
- Li-on Battery 5,0 Ah: 60 min.
- Compliant types are not limited to the above list, refer to our website for update.
- The battery voltage must match the battery charging voltage of the charger. Otherwise there is danger of
fire and explosion.
- Depending on charge state, heavily cycled batteries may take longer to charge completely
SPECIFICATIONS

INTENDED USE

EN
5