Storage And Maintenance - Car Repair System Dual Channel Manual De Instrucciones

EN
Indicator Button
- Align the battery pack with the bay and slide the battery pack into the charger until it is locked.
- The red light may come on, either continuous (battery pack is too hot or cold), or flashing (battery pack is
faulty).
- The green light will come on, flashing quickly(pack is charging)
- The green light come to flashing slowly(charging is approaching full), this pack is 80% full, it can use now, but
it is suggested to continue the charging until it is fully charged.
- When charging starts at any of the bays, the corresponding cooling fan starts to run.
- After charging is complete, the green light will come continuous on.
- Use the indicator button on the battery pack to show the how fully charged the pack is.
- The charger will keep the battery pack fully charged if it is left on the charger.
- The charger will charge the 2 battery packs in turns, the first pack been inserted in will be charged firstly, the
green light near the 2nd pack flashing very slowly (battery pack is waiting for another pack to finish charging)
- Mounting to the Wall: Use the wall mount guides to mark the hanging points.
- Store your charger in a cool, dry place.
- Unplug battery chargers and remove batteries when not in use.
WARNING!
To reduce the risk of injury, always unplug the charger and remove the battery from the charger before per-
forming any maintenance.
Never disassemble the battery or charger. Contact a CAR REPAIR SYSTEM service facility for ALL repairs.
- Clean out dust and debris from charger vents and electrical contacts by blowing with compressed air.
- Remove dirt and dust from the housing with a paint brush or dry cloth, keeping away from all electrical
contacts.
- Never use flammable or combustible solvents around batteries, charger, or tools.
- Never immerse your battery or charger in liquid or allow a liquid to flow inside them.
8
HOW TO CHARGE THE BATTERY PACK

STORAGE AND MAINTENANCE