Troubleshooting And Service Guide; Maintenance And Service - Poggio Solutions R180 Instrucciones Originales

EN TROUBLESHOOTING AND SERVICE GUIDE
PROBLEM RESOLUTION - TROUBLESHOOTING GUIDE
PROBLEM
The compressor
does not work
Compressor starts
and stops instantly
The battery does not
charge
Battery does not hold
charge
The compressor does
not reach the desired
power
The compressor
heats up

MAINTENANCE AND SERVICE

IMPORTANT: imperatively put the switch
before performing any cleaning or maintenance operation .
• Clean your compressor regularly with a damp cloth . Do not use
abrasive or solvent
• The screen of the LCD display should be cleaned carefully to
avoid scratches and bumps .
• The ventilation openings must be cleaned regularly with a
Repair of this machine should only be carried out by a qualified and approved manufacturer.
Contact your after-sales service (mentioning the make, model and serial number).
28
CAUSE
Uncharged battery
Failed battery
12 V DC adapter not connected
Cigarette lighter socket not powered
Main switch to OFF
Other causes
The mains charger is connected
and the battery is not yet
sufficiently charged (red light on)
Valve closed
Connector incorrectly plugged in
Pinched or plugged hose
The charger is faulty (red light off)
Failed battery
Main switch to OFF
Failed battery
Uncharged battery
Air leak
Intensive use
on OFF position
2
SOLUTION
Charge the battery
Contact your after-sales service to replace the battery
Connect the 12V DC adapter correctly
Check vehicle fuse
Set the main switch to ON
Contact your service center
Unplug the charger or wait until charging is complete.
Open the tyre valve
Check the position of the connector
Check the hose - have it changed if necessary.
Contact your service center
Contact your service representative to replace the
battery
Set the main switch to ON
Contact your after-sales service to replace the battery
Charge the battery or switch to 12 V mode by
plugging the compressor into the 12 V DC socket on
the cigarette lighter
Inspect the hose. Have it changed if necessary
Bad tip connection. Tighten or replace the inflation tip
Check the seals of the tips and accessories
Check the tightness of the tips and accessories
Let the compressor sit for at least 20 minutes
brush or a dry cloth, avoiding introducing objects inside the
compressor .
• The compressor must be carried in its pouch to avoid the risk of
shocks during transport or storage .
• The compressor must not be dismantled . In case of disassembly
for a compelling reason, be sure to tighten the screws
moderately during reassembly .