Pre-Test Checklist - Midea MDF24P1B Serie Instrucciones De Instalación

CAUTION
Do not O v ertig h ten Side Screw s
Close dishwasher door and verify that gap between the countertop
4.
and the top of the dishwasher door is at least
1
(1.3 cm)
5. Remove towel from dishwasher.
6. Reinstall the lower dish rack.

PRE-TEST CHECKLIST

32
1. Check that the power is OFF.
2. Check door opening and closing. If door does not open and close freely
or tends to fall, check spring adjustments. See "Check Door Balance."
3. Check that wiring is secure under the dishwasher, not pinched or in
contact with door springs or other components. See "Position the
Water Line and House Wiring."
4. Check door alignment with tub. If door hits tub, level dishwasher. See
"Level Dishwasher."
5. Pull out the lower rack, about halfway. Check that the rack does not roll
back into the dishwasher or forward onto the door. If the rack moves,
adjust leveling legs. See "Level the Dishwasher."
/ "
2
a
b
a
Remove Plastic tub cap
# 8 X 1-1/4 IN screw
Reinsert Plastic tub cap
1/4
b c
" (0.64 cm).
a
Countertop
b
Dishwasher
Door