Battery Replacement - Tripp-Lite Smartpro Smart2000Rmxl2U Manual Del Propietário

All manuals and user guides at all-guides.com

Battery Replacement

Under normal conditions, the original batteries in your UPS will last many years. See Safety section
before replacing batteries. The batteries are designed for hot-swap replacement (i.e. leaving the
UPS in ON mode), but some qualified service personnel may wish to put the UPS in the OFF mode
and disconnect equipment before proceeding. Note: Refer to the label on the battery retention
plate for the R.B.C. part number.
RBC58-2U Battery Replacement Procedure (Applies to
SMART3000RM2UP, SMART3000RMXL2U and SMART3000RMXLN
Models)
1
Remove Front Panel
1 4 x screws
2
Remove Battery Retention Plate
4 x screws
2
3
Disconnect Batteries
3
4
Remove/Recycle Batteries
First, remove the left row of batteries.
4A
Then, slide the right row of batteries to
4B
the left and remove.
4A
4B
18