JVC KD-S12 Manual De Instalación/Conexion

KD-S12
Installation/Connection Manual
Manual de instalación/conexión
GET0317-004A
[J]
ENGLISH
You need the installation kits which corresponds to your car.
• Mark all the check boxes ( ) to make sure you have follow the instructions and the listed
parts.
Parts list for installation and connection
A / B
Hard case/Control panel
F
Washer (ø5)
INSTALLATION (IN-DASH MOUNTING)
If you are not sure how to install this unit correctly, consult your JVC car audio dealer.
Do the required electrical connections.
G H
Lock nut (M5) Mounting bolt—
M5 x 20 mm (M5 x 13/16")
Bend the appropriate tabs
to hold the sleeve firmly in
place.
Check the battery system in your car.
C D
Sleeve Trim plate
When using the optional stay
Fire wall
Dashboard
Install the unit at an
angle of less than
30˚.
Removing the unit
Before removing the unit, release the rear section.
1
12 V DC, NEGATIVE ground
E
Power cord
I
Rubber cushion
When installing the unit without
using the sleeve
In a Toyota for example, first remove the car
Stay (option)
radio and install the unit in its place.
Flat type screws—
M5 x 8 mm (M5 x 3/8")
Bracket
Screw (option)
Bracket
0705DTSMDTJSC
EN, SP
J
Handles
Flat type screws—
M5 x 8 mm (M5 x 3/8")