Resetting To Factory Settings - Steelcase Flex Collection Desk Instrucciones De Uso

_______________________________________________________________
Switching the display between centimetres
and inches
A selection can be made to have the height displayed
in centimetres [cm] or inches [inch]. This selection
does not affect the actual height of the desk.
To change the unit displayed, proceed according to
the information in the table below:
EN
16
Operating and adjusting
 Press the position memory
button MEM1 and the
REM button at the same
time
 The display switches from
CM to INCH and back

Resetting to factory settings

 Press the position
 The system resets to the
Setting the displayed desk height
 Press the position
 Move the toggle switch
memory buttons MEM1,
MEM2 and the REM but-
ton at the same time
factory settings.
memory buttons MEM1,
MEM2 and the REM but-
ton simultaneously for 4
seconds.
The display shows
"ADJUST HEIGHT" and
the current value of the
desk height.
up or down to correct the
displayed desk height.
The set height starts
flashing and the blue light
bar fills up.
Please note: The desk-
top does not move during
this process.
156631