Solter HELLMET R-05 Manual De Instrucciones página 10

BEFORE STARTING TO WELD
Before using any of the welding filters be sure to remove the corresponding protection films, keep the viewing
area and the front part of the filter clean since there are the sensors that take care of the filter darkening.
Inspect all operating parts before using the display and check for signs of deterioration. Any damaged part
must be replaced immediately before use. Check the operation of the filter before each use.
Also make sure that the attachment to the protection screen is correct to prevent it from detaching in the event
of any impact, which could cause personal injury to the user.
In case the filter darkening DIN is adjustable, adjust correctly before any application. To find out the
appropriate degree for all applications, consult the section FILTER CHOICE CHART ACCORDING TO
APPLICATION of the protection screen manual.
TECHNICAL SPECIFICATIONS
Filter
Viewing Area
CE
Dimming
Reaction time (light> dark)
Sensors
Power Type
On / Off
Sensitivity
Speed Dark / Light
GRINDING
Working temperature range
Weight
All filters are marked as indicated by the CE certificate of each model. In this marking, the first number
specifies the degree of DIN protection that the filter has when it is in the open state (clear), the next number
indicates the DIN degree in the closed state (dark) indicating the minimum and maximum degree. The symbol
between the two numbers tells us if the DIN degree setting is manual or automatic. The next three numbers
indicate the type of optics, the filter's light dispersion and the uniformity of the filter's vision according to
regulations.
MODEL HELLMET R-05
110x90x9mm
100x53mm
1/1/1/2
Adjustable(DIN 5-8 9-13) (Indoor)
1/30000 s
4
Solar panel and replaceable battery CR2032
Automatic
Adjustable (Indoor)
0 , 1s MIN / 1.0s MAX
YES (Indoor)
- 10ºC to + 60ºC
0.47 Kg
10