If Something Goes Wrong - Delonghi Pac 40 Instrucciones Para El Uso

PAC40 5-07-2001 12:36

IF SOMETHING GOES WRONG

Most malfunctions are caused by a very minor and easily solved problem. So carefully check this list befo-
re contacting the Authorised Technical Service Centre in your area.
PROBLEMS
The air-conditioner
does not function
The air-conditioner
functions for a brief
period only. The
pilot lamp flashes
The appliance swit-
ches on and off
constantly
The air-conditioner
functions but the
room is not cooled
SERVICE
If the problem persists after these checks have been made, contact your nearest authorised Technical
Service Centre. Specify the model you own and the type of defect encountered.
Pagina 23
CAUSES
• if the pilot lamp is not lit
- power failure
- the appliance is not plugged in
• if the Memo Control pilot lamp is flashing
- less than 3 minutes have passed since
the appliance was last switched off
• if the pilot lamp is lit
- in conditioning mode: the temperature in the
room is already lower than the selected tempe-
rature
• the safety float has switched the appliance off
because the condensation tray inside the
appliance is full
• the control circuit board is faulty
• the condenser fas has jammed
• window open
• source of heat in the room (heater, lamp, etc.) or
the room is very crowded
• the thermostat is set too high
• the air filter is dirty
• the air-conditioner is not powerful enough for the
size or the conditions of the room
REMEDIES
• wait until the power supply is restored
• insert the plug
• wait three minutes
• slide thermostat slider slowly to
the maximum cooling position
• remove the plug from the drai-
nage tube and drain the con-
densation from the tray.
If this fault persists, contact
your nearest Service Centre.
• contact your nearest Service
Centre
• contact your nearest Service
Centre
• switch the appliance off and
contact your nearest Service
Centre
• close the window
• remove source of heat
• lower the thermostat setting
• clean the filter
23