Control Panel; Setting The Timer - Delonghi Pac 40 Instrucciones Para El Uso

PAC40 5-07-2001 12:36

CONTROL PANEL

ON/OFF Timer key
Thermostat slider

SETTING THE TIMER

Ther programmer/timer, like all clocks, must be
set to the exact time. If for example it is 4.00 p.m.
(16.00), turn the dial in a clockwise direction (fol-
lowing the direction of the arrow) until the number
16 is lined up with the tringular pointer (the arrows
indicates 4:00 p.m. approximately).
N.B.: Never turn the dial in anti-clockwise direc-
tion!
The timer is in effect, an electric clock and works
only if the plug is connected to the power supply.
Whenever the plug is disconnected or there is a
power failure, the programmer stops (the clock is
then "slow" and must be re-set.
Select operation "with timer" or "without timer".
OPERATION WITH TIMER
1) Select the desired function as shown in the
chart overleaf.
2) Press the TIMER key, the "TIMER ON" signal
lamp will come ON.
3) Make sure that the timer indicates the correct
time (see instructions on setting).
4) Set the operating times by pushing out the
notches on the dial corresponding to the
period required (each notch represent 15
mins).
20
Pagina 20
Signal lamp indicating 3 min.
wait (flashing) or working
appliance (on continuously)
Timer signal lamp ON/OFF
Air-cooling signal lamp
20
indice di
riferimento
Signal lamp mains (conti-
nuous light) or malfunction
(flashing light)
"SLEEP" signal lamp
Automatic function signal lamp
ON/OFF key
"SLEEP" key
Function
Example: from 7 p.m. to 9 p.m.
The air-conditioner will now switch on each day at
the selected times.
N.B.: If you wish to override the programmed
operating times, simply press the ON/OFF timer
key (the timer signal lamp ON will go out).
OPERATIONG WITHOUT TIMER
1) Press the TIMER ON key again, the TIMER
ON signal lamp will go out.
2) Select the desired function as shown in the
chart on page. 21.
For technical reasons, the temperature is not
expressed in degrees but by a line increasing
in thickness. We therefore recommend that
when starting up the appliance, the thermostat
be turned to maximum (thick green line = maxi-
mum cold). When the desired temperature has
been reached move the thermostat slider
slowly away from the maximum cold position
until the appliance is switched off by operation
of the thermostat. In this way the appliance has
been programmed with the exact temperature
degree required, which is then maintained
automatically by the thermostat.
Air-cooling signal lamp
max. speed signal lamp
min. speed signal lamp
Air-cooling key
Fan speed key