Inflating Sporting Equipment And Other Items; Typical Inflation Pressure - Amazon Basics B0B5Dhmn7W Manual De Usuario

button (L) to select the
6. Press the
desired pressure unit measurement
(PSI, BAR, KG/CM
7. Set the required pressure by pressing
button (N) or
the
increase/decrease the pressure. Once
the desired pressure is reached, the
displayed figure will keep flashing.
button (K) to begin
8. Press the
inflating.
9. Once inflating has finished, disconnect
the thread connector (T) from the tire's
valve stem and replace the tire valve
cap.
10. Disconnect the 12 V auxiliary cord
and plug (B) from the vehicle's 12 V
cigarette lighter socket. The display
goes off.
11. Turn off the vehicle engine.
NOTICE
The product has an auto shut off
function. Once the pre-set pressure
is reached, the product shuts off
automatically.
When inflating a totally flat
tire still fitted on a vehicle,
there should not be any
weight on it. The vehicle
must be jacked up to take the
weight off the tire. The time
taken to inflate a tire depends
upon the volume of air and
pressure required.
5.4 Inflating sporting equipment and
other items
1. Turn on the vehicle engine.
2. Roll out the 12 V auxiliary cord and
plug (B).
3. Connect the 12 V auxiliary cord and
plug (B) to the vehicle's 12 V cigarette
lighter socket. The display lights up,
the product is in standby mode (Fig. 1).
4. Pull out the hose (U), then screw the
required attachment head (F/G/H) to
the thread connector (T) (Fig. 3).
).
2
button (M) to
3
H
G
T
U
5. Insert the attachment head (F/G/H)
into the valve of the item to be
inflated.
button (L) to select the
6. Press the
desired pressure unit measurement
(PSI, BAR, KG/CM
7. Set the required pressure by pressing
button (N) or
the
increase/decrease the pressure. Once
the desired pressure is reached, the
displayed figure will keep flashing.
button (K) to begin
8. Press the
inflating.
9. Once inflating has finished, disconnect
the attachment head (F/G/H) from the
inflated item's valve.
10. Unscrew the attachment head (F/G/H)
from the thread connector (T).
11. Disconnect the 12 V auxiliary cord
and plug (B) from the vehicle's 12 V
cigarette lighter socket. The display
goes off.
12. Turn off the vehicle engine.

5.5 Typical inflation pressure

Avoid over-inflating. Never exceed
recommended pressure. The item being
inflated may burst and cause serious injury.
Vehicle tires
EN
F
).
2
button (M) to
24-32 PSI
7