For Your Safety - Amazon Basics B0753Pm57V Guia De Inicio Rapido

For Your Safety

Please read these instructions carefully and retain them for future use.
Operation
1. Refer to your vehicle owner's manual for proper jacking lift point. This area of the
vehicle is specified by vehicle manufacturer.
2. Position stands under vehicle at points specified by vehicle manufacturer as
proper load support points.
3. To adjust stands hold control lever up while lifting saddle shaft to desired height.
Push control lever down to lock pawl into teeth located in center column. Make
sure pawl is fully engaged into teeth.
4. Carefully lower load onto stands. Set both Jack Stands to the same height.
2
Saddle
Center
Column
Pawl
Control
Lever