Placing Accessories Into The Tool; Technical Specifications - Elite Mt180Kit Manual De Usuario

6. Placing accessories into the tool

Always switch the tool off first. Hold the locking button at the front of the tool down and undo the collet chuck (anti-clockwise).
Insert the collet that matches the shaft size of the accessory to be used. Place the collet nut over the collet and then insert
the accessory shaft into the collet chuck ensuring maximum shaft contact. Then tighten up the collet nut. (DO NOT USE
PLIERS).
KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE USE.

7. Technical specifications

Voltage
Maximum Output
No Load Speed
Collet chuck capacity (máx)
KEEP WORKiNG
Keep Working
120V - 60Hz
180W
10.000 - 32.000 Rpm
Max Ø 3.2 mm
04
m t 1 8 0 K i t